HP Apollo 4200 Gen9, Руководство пользователя

Страница: 118 / 193

Hardware options installation 118
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Remove the server from the rack (on page 28 ).
4.
Remove the access panel (on page 29 ).
5.
Remove the air baffle (on page 30 ).
6.
Open the DIMM slot latches.
7.
Install the DIMM.
8.
Install the air baffle (on page 32 ).
9.
Install the access panel (on page 30 ).
10.
Install the server into the rack (on page 45 ).
11.
Power up the server (on page 19 ).
After installing the DIMMs, use BIOS/Platform Configuration (RBSU) in the UEFI System Utilities (" HPE
UEFI System Utilities " on page 159 ) to configure the memory protection mode.
Expansion board options
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (
http://www.hpe.com/info/qs
).
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause ESD.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all expansion slots have either an expansion slot cover or an expansion board installed.
To install the component:
1.
Power down the server (on page 19 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Remove the server from the rack (on page 28 ).
4.
Remove the access panel (on page 29 ).