HP Apollo 2000 System, Руководство пользователя

Страница: 95 / 203

b. Install the three-slot riser cage assembly and then secure it with six T-10 screws .
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all PCI riser
cages or rear I/O blanks are installed, and do not operate the node unless all PCI slots have
either an expansion slot cover or an expansion board installed.
IMPORTANT:
If the PCIe riser cage assembly is not seated properly, then the server does not power up.
11. Install the node into the chassis .
12. Connect all peripheral cables to the node.
13. Power up the node .
Single-slot 1U node right PCI riser cage assembly options
About this task
NOTE: If installing the Single-slot 1U right PCI riser cage assembly for Processor 2 (PN 798182-B21), a
second processor is required.
NOTE: Single-slot 1U node right PCI riser cage assemblies feature different riser boards. For more
information on the riser board slot specifications, see " PCIe riser board slot definitions ."
Procedure
1. Power down the node .
2. Disconnect all peripheral cables from the node.
3. Remove the node from the chassis .
4. Place the node on a flat, level surface.
5. If installed, remove the single-slot left PCI riser cage assembly .
6. Remove the rear I/O blanks .
7. If you are installing an expansion board, remove the PCI blank.
Single-slot 1U node right PCI riser cage assembly options 95