HP A6826A, Руководство по установке

Страница: 22 / 52

Installing the Adapter
22 A6826A PCI-X Host Bus Adapter for Linux 64-bit Systems Installation Guide
Installing the Adapter
To install the HBA:
1. Check the motherboard and make any necessary configuration changes to
accommodate the HBA.
2. Power down the peripherals, then turn off the computer.
3. Remove the computer cover and save the screws.
4. Choose any PCI bus slot that supports bus mastering.
5. Most motherboards automatically assign an IRQ level and interrupt line; if
your motherboard does not, you must assign the IRQ level and use interrupt
line A for this slot.
6. Remove the slot cover for the slot in which you will install the HBA.
7. Place the HBA in the slot. Carefully press the board into the slot until it seats
firmly.
8. Secure the HBA to the chassis. Follow the server manufacturer’s instructions.
9. Connect the appropriate cable from the devices to the corresponding
LC-connector.
10. Carefully reinstall the computer cover. Insert and tighten the computer cover
screws.
11. Power up all external FC devices, then power up the server and observe the
monitor.