HP A-F1000-E, Руководство по установке

Страница: 42 / 75

37
during the process. The fast saving mode is suitable for environments where the power supply is
stable.
•
Safe saving: Executing the save command with the safely keyword. The mode saves the file more
slowly but can retain the configuration file in the device even if the device reboots or the power fails
during the process. The safe saving mode is preferred in environments where a stable power supply
is unavailable or remote maintenance is involved.
Follow these steps to save the current configuration of the firewall:
To do… Use the command… Remarks
Save the current configuration to the specified
file, but the configuration file will not be set as the
file for the next startup
save file-url
Save the current configuration to the root
directory of the storage medium and specify the
file as the startup configuration file that will be
used at the next system startup
save [ safely ]
Use either command
Available in any view
NOTE:
• The configuration file must be with extension .cfg .
•
During the execution of the save command, the startup configuration file to be used at the next system
startup may be lost if the device reboots or the power supply fails. In this case, the device will boot with
the factory defaults, and after the device reboots, you need to re-specify a startup configuration file for
the next system startup.
Rebooting the firewall
To reboot a firewall, use one of the following methods:
•
Use the reboot command to reboot a firewall.
•
Enable the scheduled reboot function at the CLI. You can set a time at which the firewall can
automatically reboot, or set a delay so that the firewall can automatically reboot within the delay.
•
Power on the firewall after powering it off, which is also called hard reboot or cold start. Powering
off a running firewall causes data loss and hardware damages, and therefore is not recommended.
Perform the following operation to reboot the firewall immediately:
To do… Use the command… Remarks
Reboot the firewall
immediately
reboot
Required
Available in user view
Perform the following operation to enable the scheduled reboot function:
To do… Use the command… Remarks
Enable the scheduled reboot
function and specify a specific
reboot time and date
schedule reboot at hh:mm [ date ]
Enable the scheduled reboot
function and specify a reboot
waiting time
schedule reboot delay { hh:mm |
mm }
Use either command
The scheduled reboot function is
disabled by default.
Available in user view