HP 8200i, Руководство пользователя

Страница: 36 / 136

1-24
If You Have Problems
than Master or Slave. If this is true, the location of the data-cable
connector (middle/end) is very important.
■
For Sony and Goldstar CD-ROMs, try configuring the CD-Writer Plus
as Master and the CD-ROM as Slave.
Does your computer meet the minimum system requirements.
See Minimum System Requirements on page A-1.
Error message when I double-click on the CD-Writer Plus icon.
■
There is no CD in the CD-Writer Plus drive. Insert a CD and try again.
■
After inserting a CD, you need to wait a moment to let the CD-Writer
Plus drive read the disc information (wait until the light on the front
of the drive stops flashing and stays green), then click on the CD-
Writer Plus drive’s icon again.
■
The CD may be in the tray upside-down or a little off-center; try
reinserting the CD. The label should be facing up.
■
You are trying to read from a blank recordable CD. Try again after
copying some information to the CD.
I already placed Software Disc 1 in the CD-Writer Plus but it
continues to prompt me to insert the CD.
■
Make sure the jumper on the CD-Writer Plus is set as advised in the
Install Recommendation Printout for your computer. (See page 1-4.)
■
Check the data cable and make sure the cable’s colored edge is aligned
with PIN-1 on the CD-Writer Plus drive. (See step 15 on page 1-11 if
you are installing in an empty drive bay, or step 16 on page 1-14 if
you are replacing an existing CD-ROM drive).