HP 780019-S01, Руководство по техническому обслуживанию и ремонту, Страница: 52 / 105

Removal and replacement procedures 52
o
Remove the server from the rack (on page 17 ).
4.
Remove the access panel (" Access panel " on page 26 ).
5.
Remove the PCIe riser cage (" Primary PCI riser cage " on page 26 ).
6.
Remove the expansion board.
To replace the component, reverse the removal procedure.
If you are not replacing the expansion board, install the screw back into the PCIe riser cage before
installing the PCIe riser cage back into the server.
M.2 SSD enablement board
To remove the component:
1.
Power down the server (on page 16 ).
2.
Remove all power:
a.
Disconnect each power cord from the power source.
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page 17 ).
o
Remove the server from the rack (on page 17 ).
4.
Remove the access panel (" Access panel " on page 26 ).
5.
Remove the PCIe riser cage (" Primary PCI riser cage " on page 26 ).
6.
Disconnect the M.2 SSD cables from the M.2 enablement boards. For more information, see "M.2
SSD Enablement Board option cabling (on page 92 )."