network speed (100 or 1000 Mbps)and the port
wiring operation (MDI-X or MDI) between the
switch and another IEEE 802.3ab-compliant device
running the 'Auto Negotiation' protocol.
- 100-full
100 Mbps, full duplex.
- auto-100
Same as 'auto'. Limited to 100Mbps network speed.
- auto-1000
Same as 'auto'. Limited to 1000Mbps network speed.
- auto-10-100 Same as 'auto'. Limited to 10Mbps or 100 Mbps
network speed.
For 1000SX, 1000LX:
- auto
(default) The port Auto Negotiates for Flow
Control if Flow Control is set to Enable.
- 1000-full
1000 Mbps, full duplex.
For 1000Stk:
- auto
Runs in 1000 Mbps, full duplex.
The port Auto Negotiates for Flow Control if
Flow Control is set to Enable.
Supported Values:
■
10-half -- 10 Mbps, half duplex.
■
100-half -- 100 Mbps, half duplex.
■
10-full -- 10 Mbps, full duplex.
■
100-full -- 100 Mbps, full duplex.
■
1000-full -- 1000 Mbps, full duplex.
■
auto -- Use Auto Negotiation for speed and duplex mode.
■
auto-10 -- 10 Mbps, use Auto Negotiation for duplex mode.
■
auto-100 -- 100 Mbps, use Auto Negotiation for duplex mode.
■
auto-1000 -- 1000 Mbps, use Auto Negotiation for duplex mode.
■
auto-10-100 -- 10 or 100 Mbps, and half or full duplex, using Auto Negotiation.
src-ip
■
interface vlan
VLAN-ID
connection-rate-filter unblock
IP-ADDR/mask-LENGTH
Match packets from the specified subnet.
■
interface svlan
VLAN-ID
connection-rate-filter unblock
IP-ADDR/mask-LENGTH
Match packets from the specified subnet.
svlan
■
[no] interface svlan
VLAN-ID
Usage: [no] svlan VLAN-ID [...]
Description: Add, delete, edit SVLAN configuration or enter a SVLAN context.
If an existing 'SVLAN VLAN-ID' is specified you are put into the
context for that SVLAN, and can then execute commands for that
SVLAN. If a new VLAN-ID is specified, the new SVLAN is added with
the VLAN-ID, and you are put into the context of the new SVLAN.
If you follow the command with one of the SVLAN Context commands
in the same command line, the context level is not changed, but
the commands are executed for the SVLAN specified by the
VLAN-ID. The 'no' option of the SVLAN command is used to delete
the SVLAN specified by VLAN-ID.
277
©
2009 Hewlett-Packard Development Company, L.P.
interface
Command Line Interface Reference Guide
Содержание 6200YL
