HP 5400R zl2 Series, Инструкция по установке и началу работы

Страница: 26 / 140

1-16
Introducing the HP 5400R zl2 Switches
Front of the Switch
Introducing the HP 5400R z
l2
Swi
tch
es
Out-of-Band Management (OOBM) Port
This RJ-45 port is used to connect a dedicated management network to the
switch.
To use: connect an RJ-45 network cable to the Management port to manage
an HP 5400R zl2 Switch through Telnet from a remote PC or a UNIX worksta-
tion.
To use this port, the switch must have an IP address. IP settings can be
configured through a Console port connection or automatically from a DHCP/
Bootp server.
A networked out-of-band connection through the Management port allows
you to manage data network switches from a physically and logically separate
management network.
For more information, see the "Network Out-of-Band Management (OOBM)"
appendix in the
Management and Configuration Guide at: www.hp.com/
networking/support.
System Reset Button
This button will reset the entire switch, including the second management
module, when powered on. This action clears any temporary error conditions
that may have occurred, executes the switch self test, and resets all network
activity counters to zero. The counters are displayed in the switch console
interface, the switch web browser interface, and through SNMP network
management applications, such as Intelligent Management Center.
Press the Reset button also after changing the module type that is installed in
any of the switch module slots while the switch is powered on. See “Hot
Swapping Switch Modules” on
page 2-27 .
You can also use the no module <slot> command to erase the old module type
configuration.
Clear Button
This button is used for the following purposes:
■ Deleting Passwords - When pressed for at least one second on either
one of the Management Modules, the Clear button deletes any switch
console access passwords that you may have configured. Use this feature
if you have misplaced the password and need console access.