HP 15-ew0 Series, Руководство по техническому обслуживанию и ремонту, Страница: 45 / 100

5. Pull the solid-state drive (2) away from the socket to remove it.
To install the solid-state drive, reverse the removal procedures.
NOTE: Solid-state drives are designed with a notch to prevent incorrect insertion.
Memory modules
To remove the memory modules, use this procedure and illustration.
Table 5-4 Memory module descriptions and part numbers
Description Spare part number
8 GB memory module (SODIMM, DDR4-3200, 1.2v) L46598-005
4 GB memory module (SODIMM, DDR4-3200, 1.2v) L83673-005
Memory module shield: The memory module shield is not available as a spare part component.
Before removing the memory, follow these steps:
1. Prepare the computer for disassembly (see Preparation for disassembly on page 34 ).
2. Remove the bottom cover (see Bottom cover on page 34 ).
3. Disconnect the battery cable from the system board (see Battery on page 36 ).
If you are replacing a memory module, remove the existing memory module:
1. Use the tab (1) and slot on the front of the memory module shield to lift and remove the shield (2).
The memory module shield is not available as a spare part component.
NOTE: When installing the memory module shield, be sure that the edges of the shield fit into all the
retention clips (3) that are built into the system board.
Memory modules 39