
Remove the touchpad:
1.
Disconnect the cable from the ZIF connector on the touchpad (1).
2.
Remove the three Phillips broadhead M2.0 × 2.0 screws (2) that secure the touchpad to the computer.
3.
Lift the top of the touchpad up slightly (3), and then pull the touchpad into the computer to remove it
(4).
Reverse this procedure to install the touchpad.
I/O board
To remove the I/O board, use this procedure and illustration.
Table 5-6
I/O board description and part number
Description
Spare part number
I/O board
M47688-001
I/O board cables
M47677-001
Before removing the I/O board, follow these steps:
1.
Prepare the computer for disassembly (see
Preparation for disassembly on page 23
2.
Remove the bottom cover (see
).
3.
Disconnect the battery cable from the system board (see
Remove the I/O board:
1.
Disconnect the two cables from the ZIF connectors on the I/O board (1).
2.
Remove the four Phillips M2.0 × 2.5 screws that secure the board to the computer (2).
Component replacement procedures
29
Содержание 14bt-cb000
Страница 4: ...iv Safety warning notice ...