8
Figure 5 LACP MAD application scenario
BFD MAD
BFD MAD can work with or without intermediate devices.
shows a typical BFD MAD
application scenario.
To use BFD MAD:
•
Set up dedicated BFD MAD link between each pair of IRF members or between each IRF
member and the intermediate device. Do not use the BFD MAD links for any other purpose.
•
Assign the ports connected by BFD MAD links to the same VLAN. Create a VLAN interface for
the VLAN, and assign a MAD IP address to each member on the VLAN interface.
The MAD addresses identify the member switches and must belong to the same subnet.
With BFD MAD, the master tries to establish BFD sessions with other member switches by using its
MAD IP address as the source IP address:
•
If the IRF fabric is integrated, only the MAD IP address of the master is effective. The master
cannot establish a BFD session with any other member. If you execute the
display bfd
session
command, the state of the BFD sessions is
Down
.
•
When the IRF fabric splits, the IP addresses of the masters in the split IRF fabrics take effect.
The masters can establish a BFD session. If you execute the
display bfd session
command,
the state of the BFD session between the two devices is
Up
.
