HP Enterprise FlexNetwork 10500 Series, Руководство по настройке

Страница: 204 / 325

195
Step Command Remarks
1. Enter system view.
system-view N/A
2. Configure the device name.
sysname
sysname The default device name is
HPE
.
Configuring the system time
Correct system time is essential to network management and communication. Configure the system
time correctly before you run the device on the network.
The system time is determined by the UTC time, the time zone, and the daylight saving time. You can
use the
display clock command to view the system time.
The device can obtain the UTC time from one of the following time sources:
•
None —Local UTC time, set by using the clock datetime command.
•
NTP —NTP time source. You must configure NTP correctly. For more information about NTP
and NTP configuration, see Network Management and Monitoring Configuration Guide .
The UTC time obtained from an NTP time source is more precise.
To configure the system time:
Step Command Remarks
1. Enter system view.
system-view N/A
2. Specify the UTC
time source.
clock protocol { none |
ntp mdc mdc-id
}
By default, the device uses the NTP time source
specified on the default MDC.
If you execute this command multiple times, the
most recent configuration takes effect.
3. (Optional.) Set the
local UTC time.
a Return to user view:
quit
b Specify a UTC time for
the device:
clock datetime time
date
c Enter system view
again:
system-view
Required when the local UTC time source is used.
4. Set the time zone.
clock timezone
zone-name
{
add
|
minus
}
zone-offset
By default, the system uses Greenwich Mean Time
time zone.
After a time zone change, the device recalculates
the system time. To view the system time, use the
display clock command.
This setting must be consistent with the time zone
of the place where the device resides.
5. Set the daylight
saving time.
clock summer-time name
start-time start-date
end-time end-date add-time
By default, the daylight saving time is not set.
After you set the daylight saving time, the device
recalculates the system time. To view the system
time, use the
display clock command.
The settings must be consistent with the daylight
saving time parameters of the place where the
device resides.