INSTALLATION INSTRUCTIONS
VL Series
Howard Lighting Products | 580 Eastview Drive | Laurel, MS 39443
(toll free) 800.956.3456 | (direct) 601.422.0033
www.HowardLightingProducts.com
Page
1
of
2
Rev:
11/7/2017
Versalite LED Wallpack
Applies to
VL12X, VL20X, VL30X, VL40X, VL50X, VL80X, VL100X, VL120X
Table 1:
Product Specifications
Where X represents CCT (3=3000K, 4=4000K, 5=5000K)
SAFETY INSTRUCTION
●
Read instructions carefully before attempting to install fixture. Retain instruction for future
reference.
●
Disconnect power before installing or servicing. This fixture must be wired in accordance with the
National Electrical Code and applicable local codes and ordinances.
●
All wiring should be performed by a qualified electrician. This fixture is for outdoor use and should
not be used in areas with limited ventilation or high ambient temperatures.
●
Please consult product specifications (Table 1) before wiring to estimate total load.
INSTALLATION
1.
Open the fixture 90° to get easy access to screws holding the back plate (figure 1). Loosen 2 screws
and take off the back plate.
Fig. 1
Fig. 2
2.
Remove weep-hole screws from the bottom of the back plate (figure 2). VL12x series has only one
weep-hole screw in the bottom center.
Model
Dimensions
(LxWxH) inches
Input Voltage
Input Current
(Max.)
Watt
Power
Factor
Dimming
VL12X
6x5x3.4
100-277VAC
0.15A
12W
≥0.9
NA
VL30X
9x7.6x4.5
0.38A
30W
NA
VL40X
347-480VAC
0.17A
40W
0-10V/PWM/VR
VL50X
100-277VAC
0.52A
50W
NA
VL80X
13x11x5.5
1.0A
80W
0-10V/PWM/VR
VL100X
277-480VAC
0.48A
100W
0-10V/PWM/VR
VL120X
100-277VAC
1.5A
120W
0-10V/PWM/VR
FIG.2
Weep-hole screws
