A
A
B
1
The 05536 Adapter Kit is to be used to install a Jacobs Chuck(sold separately) onto a "Hex Drive" spindle. The
Hex Drive Assembly will have 2) 1/4-28 X 3/8 set screws (Fig.1) at the top of the arbor body. If your HMD904 or
HMD908 does not have these set screws the Arbor Assembly is a Threaded Spindle and will require the use of
Spindle Adapter 01829.
Remove the set screws (A) from the top of the Arbor Body and the Front Support Bracket Bolts (B) from the front of
the Magnet. Once these are removed the Arbor Body Assembly can be removed from the Drill Assembly.
1
2
3
4
5
Thread the 3-Jaw Chuck onto the Spindle Adapter until tight. Now slide the complete assembly up onto the Hex
Spindle at the bottom of the motor. While pushing up on the Spindle Adapter / Chuck Assembly, turn the set screw
in at the top of the Adapter until tight; as shown in Fig.5.
Continued
Chuck sold separately
SPINDLE ADAPTER KIT 05536
For use on Hougen Drill Models HMD904, HMD908 & HMD925
