Page 4
Hotsy 1065A/1065SS
Figure 4 - Battery Dimensions
ASSEMBLY
Unpacking
Unpack carefully. Wear safety glasses or goggles while
unpacking, assembling, or operating pressure washer. If
there are missing components or hidden damage,
immediately contact carrier concerning discrepancies.
1. Cut strapping band from pressure washer and pallet.
2. Remove pressure washer from pallet.
Parts Included
• Pressure Washer
• Pressure Hose
• Wand
• Operating Instructions and Parts Manual
• Gasoline Engine Manual
• Parts Bag Containing:
■
Pressure Nozzle (3 Ea.)
■
Quick Disconnect (2 Ea.)
■
Quick Disconnect Plug
■
Trigger Gun
■
Battery Terminal (2 Ea.)
Tools Required
• 8" Adjustable Wrench
• Teflon Tape
• Flat Blade Screwdriver
Pressure Hose, Trigger Gun and Wand
1. When assembling, use teflon tape on all threaded
plumbing connections to prevent leakage.
2. Install the pressure hose on the pressure washer as
shown in Figure 2.
Figure 2 - Pressure Hose Installation
RELIEF VALVE
PRESSURE HOSE
Figure 3 - Pressure Hose Installation
TRIGGER GUN
QUICK DISCONNECT
QUICK DISCONNECT
WAND
QUICK DISCONNECT PLUG
PRESSURE HOSE
3. Assemble wand components as shown in Figure 3.
NOTE: The pressure nozzle is not to be installed at
this time.
4. Make sure all plumbing connections are tight.
Battery
WARNING: Wear eye, hand and skin protection when
handling or connecting battery.
WARNING: Batteries generate explosive gases dur-
ing normal battery operation.
WARNING: DO NOT expose the battery to flame or
sparks as these gases may ignite.
WARNING: Battery fluid is highly acidic. If battery fluid
contacts skin or clothing, wash immediately with soap
and water. If battery fluid enters eye, immediately flood
eye with running cold water for at least 15 minutes
and get immediate medical attention.
1. Place battery in battery box (battery not included).
Use a standard 12 volt automotive battery. Select a
battery similar to the one in Figure 4 for proper fit
and installation.
6-3/4"
MAX
10-1/2"
MAX
8-3/4"
MAX
