GB
3
Installation
W
ARNING - THIS APPLIANCE MUST
B
E EARTHED
.
Mains Connection
Your cooker should have been checked to ensure
that the voltage corresponds with your supply
voltage, this is stated on the rating plate, which is
situated on the outer rear panel.
The model number and serial number are located on
the front of the cooker, as shown on the Feature's
page.
The cooker must be connected by a competent
person such as one who is a, NI
CE
I
C
registered
contractor to a suitable double
-
pole control unit with
a minimum rating of
32
A and a minimum contact
clearance of
3
mm (applicable to newer properties,
older properties where a
30
A double pole control unit
and a minimum contact clearance of
3
mm is
acceptable).
The double pole control unit should be fitted
adjacent to the cooker, in accordance with I
EE
regulations. The control unit must be within
2
metres
of but not directly above the appliance and should
be easily accessible in the event of an emergency.
The power supply cable should conform to B.S.
6004
with a conductor size of
6
mm
2
, minimum.
Access to the mains terminals is gained by
removing the rear access cover. The mains cable
must pass through the cable clamp adjacent to the
terminal block. Sufficient cable should be used to
allow the cooker to be pulled out for servicing.
Ensure
that
the
mains
cable
is
routed
away
from
any
brackets
affi
x
ed
to
the
rear
panel
and
is
not
trapped
to
the
rear
wall
when
pushing
the
cooker
into
position
between
cabinets
.
Levelling
Four feet are fitted which can be adjusted up or
down to set the height (
900
mm
-
930
mm) and level
the cooker.
The feet can be simply screwed in or out to lower or
raise the cooker.
After the correct height is achieved, lock the feet
into position by tightening the locking nut using an
open ended spanner.
CAUTION:
Some soft floor coverings may get
damaged if the cooker is not moved carefully.
NOTE:
E
nsure oven shelves are level by using a
spirit level on the rod shelves.
Siting
the
Cooker
The cooker is designed to fit between kitchen
cabinets spaced
600
mm apart. The space either
side need only be sufficient to allow withdrawal of
the cooker for servicing and cleaning.
It can be used with cabinets one side or both as well
as in an angled corner setting. It can also be used
freestanding.
Adjacent side walls which project above hob level,
must not be nearer to the cooker than
150
mm and
should be protected by heat resistant material. Any
overhanging surface or cooker hood should not be
nearer than
650
mm.
Note:
This
appliance
must
NOT
be
fitted
on
a
platform
.
Moving
the
Cooker
Before moving your cooker, switch off at the cooker
control unit, ensure that it is cool.
Open the grill door sufficiently to allow a comfortable
grip on the underside front edge of the oven roof,
avoiding any grill elements.
Radio
Interference
This appliance conforms to
E
N
55014
regarding
suppression of radio and television interference.
Note:
Take
care
in
moving
the
cooker
as
it
is
heavy
.
Take
care
to
ensure
that
any
floor
covering
is
not
damaged
.
