Hotpoint EW73, Инструкция по эксплуатации

Страница: 32 / 36

32
Care and Cleaning (cont.)
CLEANING THE DOORS
Take particular care not to damage the inner surface of the door inner glass
that is coated with a heat reflective layer. Do not use scouring pads, or
abrasive powder, which will scratch the glass. Ensure that the glass panel is
not subjected to any sharp mechanical blows.
Stubborn stains can be removed by using a fine steel wool soap pad. For slight
soiling the inner glass panel may be cleaned, while still warm, without removing it
from the door. After cleaning, rinse and dry with a soft cloth.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop down doors, except take care
to support the weight of the inner glass when removing and refitting.
DROP DOWN DOORS
Remove the door inner glass as follows.
1.
Open the door fully.
2. Carefully slide the inner glass towards you and withdraw it from its
locating slots. Ensure that the door is not allowed to slam shut, due to
the reduction in door weight. Clean the glass as described above.
3. The inside of the outer door glass can now be cleaned while still fitted
to the cooker.
NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN
POSITION.
Refit the door inner glass as follows.
1.
Open the door fully.
2. Locate the inner door glass into its slots, so that the printing is readable
from the face nearest the oven in the closed position and the widest black
band is towards the bottom of the door. The inner door glass has a
special reflective coating on one side, in order to minimise surface
temperatures and energy consumption during use, it is important it is
fitted correctly.
3. Carefully slide the glass into its slots as far as it will go.