Hotpoint CH60EKKS, Инструкция по установке и эксплуатации

Страница: 26 / 28

Cleaning the glass doors
DROP DOWN DOORS
Open the door fully and
carefully slide the first
inner glass towards you,
taking care not to allow the
glass to fall.
If necessary, the glass can
be pushed delicately from
the back side.
Repeat the same
procedure with the next
glass.
Now the external glass
panel can be washed.
WARNING! As soon as the inner and middle glass
panels are removed , the door slams shut.
SIDE OPENING DOORS
Cleaning the door glass is the same as the drop
down doors.
Open the lower door
and lift out the inner
door glass
Remove the two
rubber anti-rattle
bungs
Remove the centre
glass taking care to
support the weight
of the glass when
removing and fitting
The glass panels may now be washed at the sink.
Stubborn stains can be removed by using a fine steel
wool soap pad.
Replace in the reverse order.
Ensure anti-rattle bungs are fitted before fitting inner
door glass.
BE CAREFUL NOT TO DAMAGE THE GLASS PANELS
BY PUSHING THEM TOO HARD.
When fitting the glass make sure it is fitted correctly ie
reflective face is fitted the right way round.
Ensure the glass panel is not subjected to any sharp
mechanical blows. Take particular care not to damage
the inner surface which is coated with a heat reflective
layer. After cleaning, rinse and dry with a soft cloth. For
slight soiling the inner glass panel may be cleaned,
while still warm, without removing it from the door
Warning: Oven must not be operated with inner door
glass removed.
Anti- rattle bung
The door glass is equipped with anti-rattle bungs
which prevents rattling of
the glass when opening
and shutting the oven
main door. These can be
removed for washing.
WARNING : Be careful not
to lose the bungs when
cleaning
Door and Control Panel (Glass)
Regularly wipe with a clean, damp cloth and polish with
a clean, dry cloth.
Door and Control Panel Trims (Stainless Steel)
Regularly wipe with a clean, damp cloth and polish with
a clean, dry cloth.
Replacement of the Oven Light
WARNING: Ensure that the appliance is switched off
before replacing the lamp to avoid the possibility of
electric shock.
Unscrew the glass cover, using a suitable cloth to
protect the fingers and remove carefully. Unscrew the
existing light bulb, and remove. Screw the new bulb
into position and replace the glass cover, with metal
washer, until positioned securely.
Care and Cleaning
26
EN