Hotpoint CH60EKKS Скачать руководство пользователя страница 25

Страница: 25 / 28

Main Oven Liners

- side and rear panels.

Top Oven Liners

- sides

It should not normally be necessary to clean the
'Stay clean' panels in water. If the user feels it is
desirable to do so, wash them in warm soapy water,
followed by rinsing in clean water.

Do not use

enzyme/biological washing powder, harsh
abrasives or oven chemical cleaners of any kind.

Decorative trims:

It is advisable to clean the decorative trims regularly
to prevent any build up of soiling which may detract
from the appearance of the cooker.
The recommended method of cleaning is to wipe
over the trims with a soft cloth wrung out in hot water
or mild non-abrasive cleaner. (If in doubt try the
cleaner on a small area of trim which is not
noticeable in normal use).
Then, after wiping with a cloth wrung out in clear
water, dry with a soft clean cloth.

Never use scouring pads or abrasive cleaners/
powders which may scratch the surface.

Take care during cleaning not to damage or distort
the door seals. Do not lift the door seal from the
oven chassis, if necessary remove the seal by
carefully unhooking the corner clips.
Take care that the rating label edges are not lifted
during cleaning, and furthermore that the lettering is
not blurred or removed.

Control Panel:
Wipe with a damp cloth and polish with a dry cloth.

Stainless trims:
Regularly wipe with a clean, damp cloth and polish
with a clean dry cloth.

Grill:

Remove the wire grid food support, it is best to
wash these items immediately after use to prevent
stains from being burnt on when used again. Wipe
out the Grill compartment, use a fine steel wool soap
pad to remove stubborn stains from the floor of the
compartment.

Main oven:

1.Glass Door - open the oven door fully. The glass
panel may now be cleaned. Stubborn stains can be
removed by using a fine steel wool soap pad. Do
not use scouring pads, or abrasive powder, which
will scratch the glass. Ensure that the glass panel is
not subjected to any sharp mechanical blows. For

Care and Cleaning

slight soiling the inner glass panel may be cleaned,
while still warm. For removing stubborn stains see
next page.
2.

Remove the rod shelves. Use a fine steel wool

soap pad to remove stubborn stains from the rod
shelves and the floor of the oven. Refer to the
instructions on previous page for cleaning the 'Stay
clean' panels.

Doors

Wipe over the outer door glass panels with a cloth
wrung out in warm soapy water, then after wiping
with a cloth wrung out in clear water, dry with a soft
clean cloth. Ensure that glass doors are not

Ensure that glass doors are not

subjected to any sharp mechanical blows.

Glass Inner Door Panel

Open the door fully

and unscrew the two screws

securing the glass panel,

taking care not to allow the

glass to fall. The glass panel may now be washed at
the sink. Stubborn stains can be removed by using
a fine steel wool soap pad. Ensure the glass

Ensure the glass

panel is not subjected to any sharp

panel is not subjected to any sharp
mechanical blows.

mechanical blows.

mechanical blows. Take particular care not to
damage the inner surface which is coated with a
heat reflective layer. After cleaning, rinse and dry
with a soft cloth. For slight soiling the inner glass
panel may be cleaned, while still warm, without
removing it from the door.
Warning: Oven must not be operated with inner door
glass removed.

Do not use

aerosol cleaners on this oven as they

could adversely affect the fan motor unit, and cannot
be wiped off the fan blade.

Replacement oven lamp:

WARNING: Ensure that the appliance is switched
off before replacing the lamp to avoid the
possibility of electric shock.

Open the oven door and remove the rod shelves.
Using a suitable cloth to protect the fingers grip the
light glass dome, unscrew anti-clockwise and lift.
Reach into the aperture and unscrew the lamp anti-
clockwise. Fit replacement lamp (25W 300°C rated
SES), refit dome.

Do not use the oven lamp as/for ambient lighting