4
GB
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Introduction
!
Before placing your new appliance into operation please
read these operating instructions carefully. It contains
important information concerning the safe installation and
operation of the appliance.
!
Please keep these operating instructions for future
reference. Make sure that the instructions are kept with the
appliance if it is sold, given away or moved.
!
The appliance must be installed by a qualified professional
in accordance with the instructions provided.
!
Any necessary adjustment or maintenance must be
performed after the cooker has been disconnected from
the electricity supply.
The cookers have the following technical specifications:
Category: II 2H3+
This appliance must be installed in accordance with the
regulations in force and only used in a well ventilated space.
The data badge is fitted on the rear panel. The model/serial
number can also be found on a badge located below the
left-hand oven door beneath the door seal.
Read these instructions before installing or using the
appliance and retain them for future reference.
These instructions are only valid for the countries
whose symbols appear in the manual and on the
serial number plate.
To help you make the best use of your cooker, PLEASE
READ THIS BOOKLET CAREFULLY.
Your new cooker is guaranteed and will give lasting service. The
guarantee is only applicable if the cooker has been installed
in accordance with the Installation Instructions. The cooker is
designed specifically for domestic use and responsibility will
not be accepted for use in any other installation.
When first using the cooker ensure that the room is well
ventilated (e.g. open a window or use an extractor fan) and that
persons who may be sensitive to the odour avoid any fumes. It
is suggested that any pets be removed from the room until the
smell has ceased. This odour is due to any temporary finish
and also any moisture absorbed by the insulation.
Our policy is one of continual improvement in design and
development, therefore strict accuracy of illustrations and
descriptions cannot be guaranteed.
Installation
Prior to installation, ensure that the local distribution
conditions (nature of the gas and gas pressure) and the
adjustment conditions are compatible. The adjustment
conditions for this appliance are stated on the data badge
which is fitted on the back panel.
This appliance is not designed to be connected to a
combustion products evacuation device. It must be installed
and connected in accordance with current installation
regulations. particular attention should be given to the
relevant requirements regarding ventilation.
MODEL NUMBERS
CH10450GF S, CH10455GF S, CH10456GF S
Category II2H3+ (GB. IE)
This model is set to burn NATURAL GAS (G20) at 20 mbar
but can be converted for use on BUTANE (G30) at 28-30mbar
or PROPANE (G31) at 37mbar with the use of a service kit
supplied with the appliance or available from our Service and
Genuine Parts and Accessories department (see back cover).
GAS SAFETY (INSTALLATION & USE) REGULATIONS
It is the law that all gas appliances are installed by
competent persons in accordance with the current edition
of the above regulations. It is in your interest and that of
safety to ensure compliance with the law.
In the UK, CORGI registered installers work to safe
standards of practice.
The cooker must also be installed in accordance with Current
national legislation.
Failure to install the cooker correctly could invalidate the
warranty liability claims and could lead to prosecution.
LOCATION
The cooker may be located in a kitchen, kitchen/diner or
a bed-sitting room, but not in a room containing a bath or
shower. The cooker must not be installed in a bed-sitting
room of less than 20m
3
.
When adjusted for use on BUTANE (G30) or PROPANE
(G31) the cooker must not be installed in a room or internal
space below ground level, eg. in a basement.
PROVISION FOR VENTILATION
The room containing the cooker should have an air supply
in accordance with Current national legislation.
The room must have an opening window or equivalent; some
rooms may also require a permanent vent. If the room has
a volume between 5 and 10m
3
, it will require an air vent of
50cm
2
effective area unless it has a door which opens directly
to outside. If the room has a volume of less than 5m
3
, it will
require an air vent of 100cm
2
effective area. If there are other
fuel burning appliances in the same room, in accordance with
Current national legislation should be consulted to determine
air vent requirements.
DIMENSIONS
Height: 900 - 915 mm
Widht: 1000 mm
Depth: 600 mm (excluding door handles)
GENERAL
Gas connection
Rp ½ (½” BSP female)
Pressure test point
Hotplate burner injector
Gas rate adjustment
None
Aeration adjustment
None
