6
c)
Minimum regulation of the hob burners:
•
turn the tap to minimum;
•
remove the knob and adjust the regulation screw, which is positioned in or next to the tap pin, until the
flame is small but steady.
N.B.:
in the case of liquid gas, the regulation screw must be screwed in to the bottom.
•
check that the flame does not turn off when you turn the tap quickly from high to low.
d)
Regulating the primary air of the burners:
The primary air of the burners requires no regulation.
Adapting to different types of gas
In order to adapt the oven to a different type of gas with respect to the gas for which it was manufactured
(indicated on the label), follow these simple steps:
a)
Replacing the oven burner nozzle
•
open the oven door fully
•
pull out the sliding oven bottom
V
V
Z
•
Pry the fixing tab “V” and remove the oven burner
•
Unscrew the oven burner nozzle using the socket spanner for the nozzles
“Z”
, or a 7 mm socket spanner,
and replace it with a nozzle suited to the new type of gas (see Table 1).
Take particular care handling the spark plug wires and the thermocouple pipes.
•
Replace all the parts, following the steps described above in the reverse order.
b)
Minimum regulation of the gas oven burner with thermostat:
•
light the burner as described in the paragraph “the oven knob” of the instruction booklet.
•
turn the knob to
Max
for about 10 minutes and then turn the knob to the
Min
setting;
•
remove the knob;
•
regulate the screw positioned outside the thermostat pin until the flame is small but steady.
N.B.:
in the case of liquid gas, the regulation screw must be screwed in to the bottom.
Содержание 51TGW
Страница 21: ...2 1...
