Go to page 3 for further settings:
The FSX FUNC (X=1-3) allows you to assign footswitch
functions in looper menu. The functions can be:
•
Rec/Play: Tap to recording, then tap again to start
playback
•
Stop/Clear: Tap to stop recording and hold to clear
•
FX: Tap to toggle 1/2 speed function, hold to toggle
reverse function (violet LED steady)
•
1/2 SPD: On (yellow LED on)/Off yellow LED off)
•
REV: On (white LED on)/Off (white LED off)
•
Undo/Redo: Tap to undo/redo last overdub phrases (blue
LED steady)
•
Looper Exit: Exit looper page
In page 1:
Quick access knob 1 adjusts the loop recording level (0-100).
Quick access knob 3 adjusts the loop playback level (0-100).
Go to page 2 for further settings:
Quick access knob 1 selects between setting the loop before
(Pre) or after (Post) your effects chains. The maximum
recording time is 60 seconds in both modes.
•
In Pre mode, the looper will record stereo audio without
any effects
•
In Post mode, the looper will record stereo audio with
effects
Quick access knob 3 selects between setting the loop in
chain A or chain B.
Looper
Hold footswitch 2 or press LOOPER button in main menu to open the looper menu.
The progress bar at the top will be shown in red during recording and overdubbing. It will be shown in green during playing.
In default settings, use footswitch 1 to record/play/overdub, footswitch 2 to undo/redo, footswitch 3 to stop/clear all recorded
data.
Footswitch 1 controls start (yellow LED) and stop (yellow LED) for half speed playback. Footswitch 2 controls the start (magenta
LED) and stop (magenta LED) for reverse playback. These footswitch controls correspond with the 1/2 SPD and REV buttons on
the touchscreen.
Operation
Function/S
tatus
LED Color
(Rec/Play)
LED Color
(Stop/Clear)
On with no data
Stop
None
None
Tap Stop/Clear footswitch while
loop is playing
Stop
Flashing
green
Flashing green
Tap Rec/Play footswitch when
there’s no data
Record
Steady red
None
Tap Rec/Play footswitch while
recording, overdubbing, or paused
Play
Steady green Steady green
Tap Rec/Play footswitch while
loop is playing
Overdub
Steady blue
Steady blue
Hold Stop/Clear footswitch
Clear
Quickly
flashing green
Quickly
flashing green
Each time a recorded loop plays
from the beginning
Play
Single flash
Single flash
Tap Undo/redo footswitch during
playback
Undo/redo Steady green Steady green
Please note:
1. When the loop recording reaches it’s time
limit, the looper will automatically stop the
recording and begin playback.
2. When the looper is in Post mode, changing
patches will not change already recorded
loop phrases.
3. Half-speed and Reverse functions will affect
all recorded loop phrases.
4. If you switch looper between pre/post while
it’s running, the loop will automatically stop
and be erased; switching A/B won’t affect
looping data and status, but the output may
differ depending on effects chain and
pre/post settings.
Exit looper menu
Current lopper status
Reverse on/off switch
1/2 speed on/off switch
Rec/play time
Clear all recorded data
Record/play progress bar
Previous/next patch
Looper playback level
Current patch name
Looper rec level
Next
Page
Exit the looper by pressing BACK on the upper left of the screen. The current looping status won’t be affected.
Looping operation and status modes:
Tools
9
DESIGN
INSPIRATION
