7
HH468SE 25-07-12
Warning!
This appliance will be very
hot
when in operation and due care should be taken when operating
the controls. A leather glove is provided to assist safe operation.
Do not use an aerosol spray on or near the stove when it is alight.
Air Controls
Primary Air
Primary air is controlled via the sliding air control at the bottom of the door. This provides a conventional air
under draught to the bed of the fire. The primary air is used when lighting the stoves or when the fuel bed
goes very low. The primary air inlet will usually be closed when burning wood and open when burning coal
type fuel.
Secondary Air (Air Wash)
Hothouse stoves are provided with a powerful “air wash” system. This secondary air supply to the stove is
controlled via a sliding air control located on the top right of the stove, just above the door. If you want
clean glass, always leave this control open some way whilst burning unless the stove is being shut right
down for a long period. Moving the sliding control towards the wide side of the arrow increases the burn
rate whilst moving it towards the narrow side reduces it.
Multifuel Grate
Your Hothouse Stove is fitted with a rotary style grate, which is operated from the front of the stove via a
riddle rod. Use the “Hook” end of tool to operate the riddling system. This rotary grate is located in the
centre of a cast iron flat bed with suitable air slots that assist the burning of most fuels. It is important to use
the rotary grate to de-ash regularly, to ensure that the primary airflow is not impeded, as a build-up of ash
can damage the cast iron bed.
Ashpan
It is essential that you empty the steel ash pan every day. Use the thick end of tool to hook onto and lift the
ash pan out of the stove.
DO NOT allow ash to build up underneath the bed as this may cause damage
to the grate.
Cleaning
Glass:
Despite the advanced air wash system provided, the glass will still need cleaning from time to time
depending on the fuel quality and burning rates used. Never clean glass when the stove is hot. Always use
stove glass cleaner or ceramic hob cleaner, which is available from your stove retailer. As an alternative, use
a wet cloth with some of the wood ash if burning wood but be very careful to use very clean ash so as not to
scratch the glass.
Outer body:
The outer body simply needs to be dusted from time to time. DO NOT use any kind of
furniture polish or cleaning agent other than your stove suppliers recommended paint.
Inner firebox:
Brush the inside of the firebox clean from time to time to check the integrity of the plates
and liners etc. It is not normally necessary to re-paint inside the firebox due to the high temperatures that
mean that the paint does not have much effect before being burnt off. Steel and cast iron liners are resilient
firebox materials and will give reliable service without major cleaning or work on the firebox.
Baffle:
It is essential to check the top of the baffle for build-up of soot and ash regularly when in use and
after a long period of no use. From time to time remove the baffle if necessary to ensure that the flue way
entrance is clear. Take note of the baffle orientation when removing and ensure it is refitted the same way.
