6
2. Attach the Right Handlebar Leg (32) to the Right
Pedal Arm (28) with an M8 x 32mm Screw (63)
and an M8 Locknut (54).
Do not overtighten
the Locknut; the Right Pedal Arm must pivot
easily.
Attach the Left Handlebar Leg (not shown) to
the Left Pedal Arm (not shown) in the same
way.
63
32
28
54
2
1
60
60
2
1
39
Avoid pinching
the wires
1.
Orient the Shield Cover (39) and the Upright (2)
as shown. Slide the Shield Cover upward onto
the Upright.
Have a second person hold the Upright (2) near
the Frame (1).
See the inset drawing.
Locate the wire tie in
the Upright (2). Tie the lower end of the wire tie
to the frame wires (A). Next, pull the upper end
of the wire tie upward out of the top of the
Upright.
Tip: To prevent the frame wires from
falling into the Upright, secure the frame
wires with the wire tie.
Tip: Avoid pinching the wires.
Attach the
Upright (2) to the Frame (1) with four M8 x
20mm Screws (60).
Tip: Start all the Screws
before tightening any of them.
Then, slide the Shield Cover (39) downward to
the bottom of the Upright (2).
Attach the Water Bottle Holder (19) to the
Upright (2) with two M4 x 15mm Screws (52).
52
19
To make assembly easier, read the
information on page 5 before you begin.
A
A
Wire Tie
Wire Tie