Hoshizaki KM-1601SRH3, Инструкция по эксплуатации

Страница: 19 / 46

19
2. Bin Control Installation
NOTICE
Before operating the icemaker, the bin control must be installed. Failure to properly
install the bin control could result in ice backup and icemaker damage.
a) KM-1301/1601S_H/3
1) Install the bin control thermostat as follows:
a. Remove the baffle from the ice storage bin.
b. Remove the tie securing the bin control thermostat assembly. Remove the
2 thumbscrews below the bin control thermostat assembly.
c. Remove the bin control thermostat assembly from the shipping hook by lifting it up
and shifting it to the right. Lower the thermostat extension bracket (stainless) with
the thermostat bulb attachment and thermostat bulb through the hole located at the
bottom of the icemaker. Next, lower the thermostat bracket (plastic) through the hole.
See Fig. 3.
d. Make sure the left side and bottom of the assembly are flush against the wall and
base panel.
e. Secure the assembly into place with the thumbscrews unless you are installing
an upper unit. If you are installing an upper unit, complete steps f and g and then see
"II.D.3.
Installation of Upper Unit."
f. Insert the plug into the receptacle on the assembly until it locks into place. See Fig. 4.
Shipping Hook
Bin Control Thermostat Assembly
Thermostat Bracket (plastic)
Tie
Thermostat Bulb
Attachment (plastic)
and Thermostat Bulb
Thumbscrew
Thermostat Extension
Bracket (stainless)
Hole
Wall
Fig. 3
Plug
Receptacle
Thumbscrews
Hook
Bushing
Fig. 4