Hoshizaki HR24B, Руководство по обслуживанию

Страница: 34 / 39

34
B. Component Service Information
NOTICE
When replacing a component listed below, see the notes to help ensure proper
operation.
Component Notes
Compressor Install a new PTC relay. WARNING! To reduce the risk of electric shock, be sure to
reconnect the component's ground wire.
C. Door Reversal
If you would like to reverse the door swing, follow the steps below.
1) Make sure the appliance is off and unplugged.
2) Remove the fasteners securing the top panel. See Fig. 3. Being careful not to pull on the
wires to the control panel and door switch, lift off the top panel. Secure the top panel so
that it does not interfere with the upper hinge or top panel bracket and will not fall.
3) While maintaining a hold on the door, remove the fasteners securing the upper hinge to
the right side of the appliance. Lift off the door and upper hinge.
4) Remove the top panel bracket from the left side of the appliance, then secure it to the
right side of the appliance.
5) Remove the 2 outside plastic plugs from the lower left side of the appliance.
6) Remove the lower hinge from the right side of the appliance, then secure it to the left
side of the appliance.
7) Place the 2 plastic plugs in the holes on the lower-right side of the appliance.
8) Remove the plastic plugs and the handle from the door.
9) Secure the handle to the right side of the door. Place the plugs in the open handle holes
on the left side of the door and in the hinge hole on the right side of the door.
10) Place the door onto the lower hinge,
then place the upper hinge in the
door and secure to the left side of
the appliance.
11) Make sure the door is level. If not,
adjust the door using the slots in the
hinges.
12) Check that the wiring is connected
and routed properly, then replace
the top panel in its correct position.
Secure the top panel.
Plastic Plugs
Top Panel
Bracket
Handle
Upper
Hinge
Lower
Hinge
Plastic
Plugs
Fig. 3
Control Panel
Door Switch
Top
Panel