horsch Maestro SW 1630, Руководство пользователя

Страница: 112 / 132

112 Maestro SW Owner’s Manual – Ver. 2.4 11/2018
www.horsch.com
Track Maintenance Schedule
Task
Daily
or 10h
Weekly
or 50h
Monthly
or 100h
Annual
or 500hr
5 years or
2000hr
Inspect and clean track system
X
Inspect track condition
X
Check track alignment
X
Inspect for oil leaks on idler,
mid-roller hubs and pivot
X
Grease undercarriage and track
system pivot points
X
Check track tension
X
Re-torque wheels
X
Repack carrier roller bearings
X
Replace hub and pivot oil and set
wheel bearing rolling torque
X
Daily Maintenance, or every 10 working hours
1.
Clean and remove debris from track system. Material build-up on track system components
can lead to excessive wear and premature failure.
2.
Track system inspection. Walk around the machine inspecting each track system and axle
assembly. Identifying and resolving issues early is key to improving track system life and
decreasing operating expenses. See “Track System Inspection” in the Routine maintenance
section for more information.
3.
Check rubber track alignment daily by inspecting the guide lugs. If excessive wear or chunking
of the guide lug is occurring, track alignment may need to be adjusted. For additional
information, refer to the “Track Alignment Procedure” section.
4.
Inspect idler, mid-roller and mid-roller pivot axles for leaks. If any are noted, check oil level of
the hub to be sure oil is up to the fill hole when on a level surface.