horsch LEEB PT 330, Руководство по эксплуатации

Страница: 108 / 203

NOTE
When connecting a hydraulic hose to moving
parts , the length of the hose must be dimen-
sioned in such a way that over the total move-
ment range the bending range is not lower
than permitted and/or the hydraulic hose is not
additionally subjected to tensile loads.
8.5.4 Assembly and disassembly
of hydraulic hoses
NOTE
Use only original spare hoses from HORSCH
LEEB AS.
These spare hoses withstand the chemical,
mechanical and thermal loads.
When installing and disassembling hydraulic
hoses strictly comply with the following notes.
Generally ensure strict cleanliness.
Hydraulic hoses must generally be installed in
such a way, that under any operating condition
•
tensile loads are ruled out, except loads
caused by their own weight.
•
shorter hoses are not compressed.
•
the permissible bending radii are not ex-
ceeded.
•
external mechanical effects on the hydraulic
hoses are avoided.
•
chafing of hoses on installed components or
amongst each other is prevented by appropri-
ate arrangement and fastening.
•
are possibly protected by protective jackets.
•
components with sharp edges are covered.
¾
Fasten hydraulic hoses at the intended fas-
tening points.
¾
Avoid the use of hose brackets at point where
these would obstruct the natural movement
and length change of the hose.
¾
It is not permitted to cover hydraulic hoses
with paint!
108