horsch Leeb 6 GS, Руководство по эксплуатации, Страница: 135 / 154

135
9.8.4 Assembly and disassembly
of hydraulic hoses
Use only genuine spare hoses from
HORSCH LEEB AS.
These spare hoses withstand the
chemical, mechanical and thermal
loads.
¾
Generally use hose clamps made of V2A
when installing hoses.
When installing and disassembling
hydraulic hoses strictly comply with the
following notes:
Generally ensure strict cleanliness.
Hydraulic hoses must generally be installed in
such a way, that under any operating condition
¾
tensile loads are ruled out, except loads
caused by their own weight.
¾
shorter hoses are not compressed.
¾
the permissible bending radii are not ex-
ceeded.
¾
external mechanical effects on the hydraulic
hoses are avoided.
¾
chafing of hoses on installed components or
amongst each other is prevented by appropri-
ate arrangement and fastening.
¾
If necessary protect hydraulic hoses with
protective covers.
¾
Cover sharp edged components.
¾
Fasten hydraulic hoses at the intended fas-
tening points.
¾
Avoid the use of hose brackets at point where
these would obstruct the natural movement
and length change of the hose.
¾
It is not permitted to cover hydraulic hoses
with paint!
When connecting a hydraulic hose to
moving
parts , the length of the hose must be dimen-
sioned in such a way, that over the total move-
ment range the smallest bending radius is not
fallen short of and/or the hydraulic hose is not
additionally subjected to tensile loads.
9.8.5 Oil change PTO-shaft pump
Wear your personal protective outfit
(appropriate clothes, nitrile- / butyl
gloves, goggles, etc.).
c
a
b
Oil tank
(a) Inspection glass
(b) Filler opening
(c) Drain valve
9.9 Calibrating the flow meter
In this respect pay attention to the operat-
ing instructions from Müller Elektronik, job
computer for the crop protection sprayer .