horsch Leeb 6 GS, Руководство по эксплуатации, Страница: 132 / 154

132
9.7.2 Assembling tyres (workshop
work)
Remove any corrosion found on the
tyre contact area of the rims before
assembling a new / different tyre.
¾
When travelling, traces of corrosion can cause
damage to the rims.
¾
When assembling new tyres always use new
tubeless valves or tubes.
¾
Always screw valve caps with integrated seal
on the valves.
9.7.1 Tyre pressure
The required tyre pressure depends on
- tyre size.
- bearing capacity of tyres.
- travel speed.
The performance of tyres is reduced by
- overloading.
- too low tyre pressure.
- too high tyre pressure.
Check the tyre pressure regularly on cold
tyres (before starting to drive) (see 2.9.2).
The difference in tyre pressure between
the tyres on one axle must not exceed
0.1 bar.
After fast travelling or under warm
weather conditions the tyre pressure may
increase by 1 bar. Do not reduce the tyre
pressure, because it may then be too low
after the tyres have cooled down.