horsch Leeb 5.280 VL, Руководство по эксплуатации

Страница: 244 / 308

Flushing in liquid preparations
during filling
Water systems Basic and water system CCS
1. Connect the suction hose to the filling con -
nection.
Filling port
2. Open the filling valve.
3. Set the pressure side valve to illuviation
valve.
4. Turn the suction side valve to external suc-
tion.
5. Switch on the pump on the terminal.
6. Open the lid on the illuviation valve.
7. Fill the preparation quantity calculated and
measured for filling the tank into the illuvia-
tion valve.
8. Turn the switch-over ball valve (5) to the po-
sition for sucking-off. Have the content com -
pletely sucked off from the illuviation valve.
9. Close the switch-over ball valve (5) again.
The process may need to be repeated if the
required preparation could not be filled in
during a single process.
10. Pre-clean the illuviation valve with the rins-
ing nozzles (4).
11. Open the switch-over ball valve (5) and have
the contents sucked off.
12. Close the switch-over ball valve (5) again.
13.
Switch off the pump on the terminal.
14. Set the pressure side valve to filling
15. Top up the water shortfall.
16. Adjust the desired agitator power.
5
1
2
3
4
During the filling process the water sucked in
through the suction hose is present at the illu-
viation valve.
Stop filling when the desired tank content has
been reached.
Use the washing gun to remove any residues
from the illuviation valve. Pull lever (2) and op-
erate the gun.
Make sure that no undesired point-type entries
of preparation are generated!
240 241