horsch Leeb 5.280 VL, Руководство по эксплуатации

Страница: 17 / 308

¾
Travel characteristics, steering and braking
ability are influenced by attached or hitched
up equipment and ballasting weights. You
should therefore pay attention to sufficient
steering and braking ability!
¾
Check the brake and hydraulic system for
apparent faults before road travel.
¾
The parking brake must be fully released and
the service brake functioning.
For road transport the machine must be set to
transport position. The folding boom must be
folded up and secured. The stroke of the paral-
lelogram and the optional rear axle steering must
always be locked during road travel.
¾
Check lighting, warning and protective features
for functioning and cleanliness.
The permissible maximum speed speci-
fied in the type approval must be com-
plied with for transport on public roads!
The specifications in the type approval
document or in the technical data are
decisive for the design dependent top
speed.
Always match the travel mode to the
road conditions to avoid accidents and
damage to the undercarriage.
Consider your personal abilities, carriage
way, traffic, sight and weather conditions.
In addition, pay attention to the notes in
chapter Commissioning !
Safety in operation
Commissioning
The operational safety of the machine cannot be
guaranteed without orderly performed commis-
sioning. This can lead to accidents with severe
or even fatal physical injuries.
¾
The machine must only be put into operation
after receiving instructions by employees of
the authorized dealer or a HORSCH em-
ployee.
¾
The machine registration form must be com-
pleted and returned to HORSCH.
All protective features and safety equipment,
such as detachable protective devices (wheel
chocks, etc.), must be correctly in place and
reliably functioning before the machine is put
into operation.
¾
Check nuts and bolts, especially on wheels,
regularly for a tight fit and re-tighten if neces -
sary.
¾
Check the tyre pressure at regular intervals,
see maintenance overview.
Damage to the machine
Damage to the machine can impair the op-
erational safety of the machine and cause ac-
cidents. This can lead to severe or even fatal
physical injuries.
The following machine parts are particularly
important for safety:
¾
Hydraulics
¾
Brakes
¾
Connecting features
¾
Protective features
¾
Lighting
13