horsch LEEB 4 LT, Руководство по эксплуатации

Страница: 73 / 162

4.1.2 BoomControl modes
Six different equipment versions are available. De -
pending on the mode, there are two designs each.
BoomControl ECO
Design with 2 or 4 sensors for height adjustment
and slope compensation.
BoomControl PRO
Design with 4 or 6 sensors for height adjustment,
slope compensation and angle adjustment.
BoomControl PRO+
Design with 6 or 10 sensors for height adjust-
ment, slope compensation and angle adjustment
of inner wings and outer wings.
NOTE
In case of irregular population and/or empty
spaces in the population, the boom control must
be deactivated or manually overridden, to avoid
unintended lowering of the boom!
4.2 Folding and unfolding
WARNING
Danger of crushing, being pulled in, being
caught or impact for third parties may arise
if third parties remain in the operating range
of the boom when unfolding or folding the
boom and are caught by the moving parts
of the boom!
These endangerments can cause severe and
possible also fatal injuries.
Keep a sufficient safety distance to moving parts
of the machine as long as the engine is running.
Make sure that persons keep a sufficient safety
distance to moving parts of the machine.
Order persons to leave the slewing range of
the machine.
Immediately release the actuator for unfolding
or folding the boom, if a person enters into the
slewing range of the boom.
DANGER
Always keep a sufficient distance to over -
head power lines when unfolding or folding
the boom! Contacting overheat power lines
can cause fatal injuries.
CAUTION
There are shearing and crushing points on
all hydraulically actuated folding compo-
nents! Folding or unfolding the spray boom
while travelling is prohibited!
Only drive with the machine in locked trans-
port position.
NOTE
The folding boom is controlled via the terminal.
In folded and unfolded condition of the boom, the
hydraulic cylinders for folding the boom maintain
the corresponding end position (transport and
working position).
72 73