horsch Leeb 4 AX, Руководство по эксплуатации

Страница: 139 / 161

6. Switch off the PTO-shaft.
7. Uncouple both hoses of the test adapter set
on the test device and on the sprayer.
8. Establish the hose connection again on
the flow meter on the middle section of the
machine. Ensure a correct and watertight
connection!
Storage
¾
Clean the machine thoroughly. Chaff and dirt
will attract moisture, which causes corrosion.
¾
To prevent the brake pads from sticking to the
brake drum, apply the brake of the machine
after washing until it warms up to allow any
water that has entered to evaporate.
¾
Park the machine indoors and secure with
wheel chocks against rolling away.
¾
Unplug the terminal and store it in a dry place.
¾
Protect the machine against corrosion. For
spray coating use only biodegradable oils.
¾
Protect the hydraulic cylinder piston rods
against corrosion.
NOTE
¾
Do not spray the plastic and rubber parts with
oil or corrosion protection agent. These parts
could become brittle and break.
At the end of the season
NOTE
If a high pressure cleaner is used for cleaning,
do not direct the water jet to bearings, electrics/
electronic components and sensitive cover
panels.
¾
Clean the filter elements of suction and pres -
sure side.
¾
Lubricate the crop protection sprayer accord-
ing to the lubrication plan.
¾
Grease the visible threads of setscrews and
similar.
¾
Wet all lever joints and bearing points, which
are not subjected to lubrication, slightly with
oil.
NOTE
Make a note of all service and maintenance work
that has to be done before the start of the next
season and place a corresponding order with
your HORSCH sales partner in due time. Your
HORSCH sales partner will be in a much better
position to execute the maintenance service and
possibly necessary repairs outside the season.
Drain
Draining the spraying mixture container
1. Switch off all functions.
2. Open the suction filter.
3. Remove the cap on the residue drain.
4. Put a suitable collecting vessel under the
drain.
5. Set the directional valve on the suction side
to spraying mixture container and the directional
valve on the pressure side to circulation/spray-
ing . Open the ball valve for the residual drain.
6. Empty the pressure filter via the valve.
7. Now close the ball valve for the residue drain
again and close the connection with the cap.
8. Properly dispose of the collected remaining
solution.
133