horsch LEEB 12 TD, Руководство по эксплуатации, Страница: 143 / 181

Lubrication instructions
NOTE
¾
Lubricate all grease nipples (keep seals
clean).
¾
Lubricate the lubrication points on the middle
section and folding boom every 50 operating
hours or once every week!
¾
Lubricate the lubrication points on the basic
machine every 100 operating hours!
Lubricate / grease the machine at the indicated
intervals. Carefully clean lubrication points and
grease gun before lubricating, so that no dirt is
pressed into the bearings. Press the contami-
nated grease completely out of the bearings and
replace it with fresh grease!
Lubricants
NOTE
¾
A lithium-saponified multi-purpose grease
with EP additives must be used for lubrication
tasks.
¾
Use only cleaned hydraulic oil that complies
with the demanded cleanliness class:
•
Cleanliness class 9 as per NAS 1638
•
Cleanliness class 18/16/13 as per ISO 4406
Brand Lubricant designation
Normal
operating conditions
ARAL Aralub HL 2
FINA FINA Marson L2
ESSO ESSO Beacon 2
SHELL SHELL Ratinax A
Brand Lubricant designation
Extreme
operating conditions
ARAL Aralub HLP 2
FINA FINA Marson EPL-2
ESSO ESSO Beacon EP 2
SHELL Tetinax AM
Steering cylinder heads on steering axles
Besides these lubrication tasks make sure also
that the steering cylinders and the supply lines
are always properly bled.
Brake shaft bearings, outer and inner
CAUTION
No grease or oil must enter into the brake. Use
only lithium saponified grease with a dropping
point higher than 190 °C.
138 139