horsch LEEB 12 TD, Руководство по эксплуатации, Страница: 116 / 181

Increasing the travel speed while leaving both
nozzle size and spraying pressure unchanged,
reduces the placing quantity.
Reducing the travel speed while leaving both
nozzle size and spraying pressure unchanged,
increases the placing quantity.
The travel speed is freely selectable, based
on the automatic, area related placing quantity
control via the spraying computer.
The agitator normally remains switched on from
filling to the end of spraying. The information
provided by the preparation manufacturer are
decisive in this respect.
Example:
Required application quantity: 200 l/ha
Intended
Travel speed: 8 km/h
Nozzle type: AI / ID
Nozzle size: 03
Permissible pressure range
of the installed spraying nozzles:
3 bar (min.) -
8 bar (max.)
Intended spraying pressure: 3.7 bar
Permissible spraying pressures: 3.7 bar ±25%
2.8 bar (min.) -
4.6 bar (max.)
Spraying
1. Switch on the terminal.
2. Adjust the agitator.
3.
Prepare the spraying mixture as specified
by the crop protection agent manufacturer
and stir it up.
4. Unfold the spraying boom.
5. Set the working height of the spraying boom
(distance between nozzles and plants) in
dependence of the nozzles used according
to the spraying table.
6. In the terminal check the value “min. pressure”
and “max. pressure” for the permissible
spraying pressure range (for the installed
spraying nozzles).
7. Enter the value for “Nominal quantity” for the
required application quantity into the terminal
or check the stored value.
8. Switch on spraying via the terminal.
¾
For more information on the adjustment of
parameters, refer to the HORSCH Terminal
operating instructions.
NOTE
Comply with the applicable country specific
regulations! Comply with regulations con -
cerning the distance to waters and adjacent
areas!
Travelling to the field with the agitator switched on:
¾
Switch on the agitator via the terminal and
adjust the intensity.
112 113