horsch Joker MT-Series, Руководство пользователя

Страница: 41 / 54

M T - S e r i e s J o k e r O w n e r ’ s M a n u a l 41 | P a g e
Assembly, Mounting the Packer
Dropping and rolling machine parts can cause severe crushing, etc.
• Support the raised machine by appropriate means and secure the packer against rolling away.
• Comply with the accident prevention instructions.
Perform this function on all packer bearings of this style:
1. Place the inside M16 socket bolt (a), outside M50
slotted bolt (b) and bearing housing into each other
as shown.
2. Slide the conical ring (c) on to the outside slotted
bolt.
3. Screw the conical nut (d) on to the inside socket bolt.
4. Press the conical nut against the outside slotted bolt
(e).
Do not use force!
5. Lubricate the external threads with grease or anti-
seize.
6. Screw the bearing with the outside slotted bolt into
the threaded hole of the packer frame tube. Using a
55mm socket wrench tighten and torque to 270
ft./lbs. +/- 15 ft./lbs.
7. Then, using a 14mm Allen wrench tighten the inside
socket bolt against the slotted bolt assembly.
Torque to 130 ft./lbs. +/- 15 ft./lbs.
NOTE: Pull out the socket bolt if it can’t be
tightened and press the conical nut (d) against
the end of the outside slotted bolt. It is
important this be done correctly to seat the
socket bolt and allow the slotted bolt to secure
properly within the packer frame tube.
8. Bolt the packer assembly to the frame (g) with the
correct number of square shims (f) as shown using
the M16 countersunk bolts and retaining hardware.
Using a 10mm Allen wrench tighten and torque to
230 ft./lbs. +/- 15 ft./lbs.
NOTE: Add or remove square shims to adjust
the packer to the frame according to tolerance.
IMPORTANT! No more than four (4) square
shims may be used per bearing housing side!