horsch Joker MT-Series, Руководство пользователя

Страница: 39 / 54

M T - S e r i e s J o k e r O w n e r ’ s M a n u a l 39 | P a g e
RingFlex Packer
The RingFlex system can be attached as a rear packer on the machine. While in field use, the
packer is used to lift/lower the machine.
The RingFlex system consists of a frame support, numerous spring half-rings, heavy duty 50mm
greaseless maintenance free bearings and miscellaneous shims and hardware.
While in use in the field the machine always travels on the packer
.
NOTE: Never exceed a maximum operating speed of 8 mph while traveling on the
RingFlex system only during ‘Field’ mode.
The packer is not rated for extreme loads at high speeds, only for machine weight for short
distances, such as turning around at the end of a field or traveling across a headland.
Due to the weight of the machine a high consolidation and a fine, crumbly, level surface is
achieved.
With cohesive soils the packers may pick up more soil and thus become considerably heavier.
This can overload components or soil the roads during transportation.
Packers must therefore always be cleaned before road transportation if
they have picked up soil.
Setting the RingFlex Packer:
The RingFlex packer is used as an adjustment tool for setting desired tillage depth of the coulter
disc blades. Depending on the version machine, it may be equipped with either an Electronic
Depth Control system, or a Manual Depth Control System. For specific instructions in setting
the machine depth with the RingFlex packer system see information in Depth Setting previously
in this section.
Maintenance:
Periodically, the RingFlex packer system and its components should be inspected for wear,
along with proper torque to hardware securing its components. There is nothing on the
RingFlex packer system that requires lubrication. See illustrations below for items that require
attention for proper torque and inspection. For further maintenance items see ‘ Preventative
Maintenance ’ later in Section 7 of this manual.