horsch Joker MT-Series, Руководство пользователя

Страница: 37 / 54

M T - S e r i e s J o k e r O w n e r ’ s M a n u a l 37 | P a g e
Setup Procedure
On hard level surface:
1. Unhook tractor and implement with Roll-Flex upper depth control pins removed.
2. Set tractor lower link arms to allow lateral float.
3. Adjust lower links so both are at same height.
4. Raise the three-point hitch so that the lower links are just touching the lower mounting pins
on the implement. (Record three-point lever location.)
5. Lower the three-point of the tractor to an even distance from the lower mounting pins (i.e.
2”) and record lever location. This will provide the correct depth setting in the field and
give the operator a scale by which to adjust depth from.
6. Attach the tractor to the implement, placing the three-point hitch so that it’s at the position
found in Step 4.
7. Adjust top link so that it’s tight.
In Field Setup:
1. Start a pass in the field and adjust to desired working depth.
2. Continue pass in the field and observe the three-point hitch movement side-to-side. Stop
the tractor with the implement still in the ground and observe three-point. If the implement
is pulled tight to one sway block, adjust top link to correct. The implement is leveled
correctly when the three-point “floats” side-to-side when at working speed and depth in
the field.
3. Install Roll-Flex depth control pins at a setting that allows for constant pin contact with
packer frame. Do not allow Roll-Flex frame to hammer against pins while operating; this
will cause excessive wear on the frame and pins and provide inconsistent performance.
4. Continue on the same pass in the field and adjust top link accordingly to minimize side
draft.