Operation
Whenever working on the machine
pay attention to the associated safety
notes in the chapter “Safety and
prevention of accidents” as well as
the accident prevention instructions!
Commissioning / Tractor
change
During initial commissioning and when chang-
ing the tractor, the machine must be adapted
to the tractor.
WARNING
Dropping / lowering machine parts can cause
severe crushing injuries etc.!
¾
Instruct persons to leave the danger zone.
¾
Comply with the accident prevention instruc-
tions.
Adapting the drawbar
On all machines with drawbar eye the drawbar
must be adjusted to the height of the drawbar
hitch on the tractor before the machine's initial
use.
If fitted with tractor link arm the height can be
adjusted by the tractor link arm adapters.
Hydraulic cylinder for drawbar
Height of the drawbar hitch:
lower bore 480 - 550 mm
upper bore 550 - 600 mm
¾
Support the drawbar at the front with a height
adjustable jack.
¾
Pull out the bolt on the hydraulic cylinder.
¾
Correct the height of the drawbar and reinsert
the bolt.
Connecting and transport
position
DANGER
There is a risk that persons may become
crushed and severely injured between machine
and tractor!
¾
Instruct persons to leave the area between
tractor and machine.
DANGER
Danger of severe accidents when manoeuvring.
Keep an eye on your environment.
¾
Keep persons (children) out of the manoeu-
vring range of the machine.
DANGER
Serious accidents caused by the machine roll-
ing away!
¾
When connecting machines with pneumatic
brake always connect the
yellow
connection
(brake line) first.
WARNING
Leaking hydraulic fluid can cause serious in
-
juries! Danger of injury by unwanted machine
movements.
¾
Connect and disconnect the hydraulic lines
only when the hydraulics have been de-
pressurized on both machine and equipment
sides.
29
