Use in the field
NOTE
¾
The machine must be in horizontal position
when used in the field.
¾
Do not drive in reverse with the machine
lowered.
The components have only been designed for
forward travel in the field and may be dam
-
aged when reversing.
¾
Unfolding the machine in the field, see chapter
Unfolding.
¾
The pressure gauge for the preload pressure
(basic setting 60-70 bar) is located below the
right folding cylinder.
Pressure gauge - preload pressure
Position
Control unit
Floating position
Locked position
Unfolding / Folding
Lift / Lower
Cutting blade roller
Position of
control units during use in the field
¾
Lower the cutting blade roller with pressure,
see
Cutting blade roller
section.
¾
The packer should have contact with the
ground during use. If necessary, reduce the
pressure of the cutting blade roller, see
Cutting
blade roller
section.
Headland
¾
Slightly brake the machine at the headland.
¾
The pressure level of the cutting blade roller
can be slightly reduced on the headland, see
Cutting blade roller
section.
¾
Make sure the radius is large enough at the
turn.
38
