MAN0965-03-EN
Specifications/Installation
10/15/2013
No part of this publication may be reproduced without the prior agreement and written permission of Horner APG, LLC. Information in this document is subject to change without notice.
Page
4
of
6
6. NETWORK DATA
Consumed Digital Data
– This data is sent from the controller to the SmartBlock.
For typical applications the I/O configuration
setup in Cscape will automatically populate this data.
For more advanced applications you may use NetPut functions to write this
data. Please see the advanced programming guide MAN0880 for more details.
Bit
Description
1-8
Mode Bit 1 bit per channel
0 = Voltage Mode 1 = Current mode
17-20
Scale Bit 1 bit per channel
0 =
10V or
20mA 1 =
5V or 4-20mA
73-80
Hold Last State
1 = Hold last State 0 = go to default value
Consumed Analog Data
– This data is sent from the controller to the SmartBlock.
For typical applications the I/O configuration
setup in Cscape will automatically populate this data.
For more advanced applications you may use NetPut functions to write this
data. Please see the advanced programming guide MAN0880 for more details.
Word
Description
1-8
Analog Data
Data for analog output channels 1 to 8
9-16
Default Data
Analog output default state on error or stop (if selected)
Produced Digital Data
– This data is sent from the SmartBlock to the controller.
Normally this data is mapped into specific
registers in the I/O configuration in Cscape.
For advanced applications NetGet functions can be used to obtain this data. Since this
data is broadcast to all controllers on the network additional controllers can use NetGet functions to obtain this data as well.
Bit
Description
1-32
Not Used
33-48
Status and Diagnostic Data
49-56
Firmware Version
57-64
Device Class
– 10 for the DAC207 68 for DAC107
7. SETTING ID SWITCHES
CsCAN Network IDs are set using the hexadecimal number system from 01 to FD. The decimal equivalent is 1-253. Refer to following
Conversion Table, which shows the decimal equivalent of hexadecimal numbers. Set a unique Network ID by inserting a small Phillips
screwdriver into the two identical switches.
NOTE:
The CsCAN Baud Rate for SmartBlock I/O is fixed at 125KBaud
