since 1945
StreetFlash
Quick Guide
There are two buttons to operate the StreetFlash:
–
On / off button
π
–
Pi button
The table shows the buttons’ functions, if pressed individually or simultaneously. There is either a “tap” or “hold
3 sec” option to operate the buttons.
It also matters whether the
light is switched on or off
when pressing the buttons, as the functionality changes
accordingly. Once a group is synced, each individual lamp can be used as a remote control for the whole group.
Kontrollleuchte ist aus
Power on:
1 x
tap
STREETFLASH IS OFF
STREETFLASH IS ON
Power on:
1 x
π
tap
Check battery status:
π
hold 3 sec
max. 5 yellow flashes = full
1 or 2 red flashes = low battery
π
De- / activate auto turn on function:
+
π
hold 3 sec, 1 x
π
tap, wait 5 sec
This function is switched on by default and should
only be deactivated if necessary.
π
Change light pattern:
1 x
tap
1. (default) running light, 2. quick running light,
3. simultaneous flashing, 4. permanently on
Turn off all lights in group:
hold 3 sec
Change tilt sensor settings:
1 x
π
tap
1. automatic, 2. top LEDs, 3. side LEDs
Turn off this light only:
π
hold 3 sec
Reverse sequence of running lights:
1 x
+
π
tap
Pairing mode on / off:
+
π
hold 3 sec
Allows the formation of separate groups if necessary.
LED-CONTROL LIGHT
Glows green for approx. 5 sec:
Powers on
Glows red for approx. 5 sec:
Powers off
Flashes red:
Pair mode on
1
Glows permanently red while plugged in:
charging in progress
Glows permanently green while plugged in:
charging process completed
Flashing while plugged in:
battery error
unplug and plug in again
2
1
Each additional lamp which is switched on becomes part of the group. The pair mode
turns itself off after 5 min or if you hold both buttons for 3 sec. Now you can start a
separate group.
2
If the control light continues to flash, please contact our service team.
