Horizon Fitness SmartStacker, Руководство пользователя

Страница: 81 / 412

81 SmartStacker User's Manual
Finishing Line Controller Screen Descriptions
1-3-2
Run - Main Screen - Part 2
5
Preset Counter
If you check this box when the machine is used in a
Near Line system, the machine automatically stops
after processing the preset number. See the next
procedure to set the unit of preset counter.
Number of Processed Unit
Click this to clear the number of processed unit.
Number of Preset Unit
6
Unit of Preset Counter
Select a unit among the three units (job, sheet, of
block) for the unit of preset counter.
7
Stop Timing
This sets the actual timing to stop the machine if you
click the Stop button when the machine is used in a
Near Line system.
Immediately : The machine stops imemdiately.
End of Block : The machine stops when the currently
processing job comes to an end.
End of Job :
The machine stops after finish
processing the currently procesing job.
1
Starting the Changeover
When you click this button for a particular machine,
the changeover will begin only on that machine.
The machine will do the changeover for the job
selected from the list of Pending jobs of FLC.
Usually, the changeover is done automatically when
the system begins to run a job.
2
Job Name
The name for the job currently being run is
displayed here.
In case that several jobs are running, the name of
leading job will be displayed until it complete.
3
Job Progress Indicator
The progress of the job currently being run is shown
here.
4
Process Counter
If a SmartStacker is connected, this counts the
sheets that have been fed. If another kind of
machine is connected, this can count sheets,
pages, or blocks, depending on the type of
machine.
(The display shown to
the right will be displayed
only when the machine is
stopped.)
5
6
4
1
2
3
7