Horizon Fitness 7.0AT-03, Руководство по обслуживанию

Страница: 7 / 48

P
REVENTIVE
M
AINTENANCE
Table of Contents
7.0AT-03
7 Service Manual
Every 3 Months or 150 Miles
It is necessary to lubricate your treadmill running deck every three months or 150 miles (241 kilometers)
to maintain optimal performance.
Your treadmill came with a bottle of lubricant which can be used for two applications.

Turn off the treadmill with the on/off
switch, then unplug the power cord at the
wall outlet.

Loosen both the rear roller bolts. (For
best results, place two removable marks
on both sides of the frame and note roller
position). Once the belt is loosened, take
the bottle of lubricant and apply it to the
entire top surface of the running deck.

Tighten both rear roller bolts (matching
up the marks for proper position) to
original position. After you have applied
lubricant, plug in the power cord, insert the safety key, start the treadmill and walk on the belt or
two minutes to spread the lubricant.

Lubricate the air shocks with Teflon based spray.

When lubrication is complete, hold the “speed up” (+) and “stop” keys for seconds. This will
remove the message.
Tensioning & Centering the Running Belt
If you can feel a slipping sensation when running on the treadmill, the running belt must be tightened. In
most cases, the belt has stretched from use, causing the belt to slip. This is a normal and common
adjustment. To eliminate this slipping, turn the treadmill off and tension both the rear roller bolts using
the supplied Allen wrench, turning them ¼ turn to the right as shown. Turn the treadmill on and check for
slipping. Repeat if necessary, but never turn the roller bolts more than ¼ turn at a time. Belt is properly
tightened when the slipping sensation is gone.