S
YSTEM
P
ARAMETERIZATION AND
O
PERATION
System 6844(RC) - V03.00
53 / 157
hopf
Elektronik GmbH
Nottebohmstr. 41
• D-58511 Lüdenscheid • Tel.: +49 (0)2351 9386-86 • Fax: +49 (0)2351 9386-93 • Internet: http://www.hopf.com • E-Mail: [email protected]
5.2.7.2 Selection Frames for Parameters of Serial Interface COM1
S E T C O M _ 1 S E R I A L
P A R A M E T E R Y / N _
The parameters for the COM1 interface are entered in the same way as for COM0.
The parameter settings have no effect on the serial interface COM1 in case
of synchronisation of System via serial interface by the
hopf
Master/Slave
string. At this, the parameters are firmly adjusted to 9600baud, 8 data bit, no
parity an stop bit.
5.2.8 LAN Board Parameters (Option)
Further information and an explanation of the parameters are available in the respective LAN
Board description.
5.2.8.1 Selection Frames for LAN Board 1 Parameters
Setting the IP address
Selection frame:
S E T L A N _ 1
I P - A D R .
Y / N
Input frame:
L A N _ 1
I P - A D R .
>
1 9 2 . 1 6 8
.
2 0 2 . 2 1 0
Setting the Gateway address
Selection frame:
S E T L A N _ 1
G A T E W A Y - A D R . Y / N
Input frame:
L A N _ 1
G W - A D R .
>
1 9 2 . 1 6 8 . 2 0 2 . 0 1 0
Setting the Network Mask
Selection frame:
S E T L A N _ 1
N E T M A S K
Y / N
Input frame:
L A N _ 1
N E T M A S K
>
2 5 5 . 2 5 5 . 2 5 5 . 0 0 0
Setting the Control Byte
Selection frame:
S E T L A N _ 1
C T R L . - B Y T E
Y / N
Input frame:
C T R L . - B 7 6 5 4 3 2 1 0
L A N _ 1 >
0 0 0 0 0 0 0 0
