1
6
7
8
6
7
2
3
4
5
1
2
3
4
5
1
6
7
2
3
4
5
1
3
4
5
1
2
3
4
5
Fig. 1
horizontal
www.hopetech.com
HLDP1ESEU - Kit 1 (Euro)
HLDP1ESUK - Kit 1 (UK)
HLDP2ES - Kit 2 (No Charger)
HLDP3 - Kit 3 (No Battery & Charger)
INSTRUCTION MANUAL
HIGH POWER LED REAR LIGHTING SYSTEM
CONTENTS
Light Source:
3 x red Osram Oslon LEDs
Intensity:
105 measured lumens - High
Beam:
270 degrees visibility
Mounting:
QR Elastic Ring Mount
Battery:
7.4v Li-Ion 2600/5200mAh compatible
Charge Time:
3hrs for 2600mAh battery
Weight:
135g with splitter cable
Power Levels:
6 functions
Burn Time:
15 - 200 hours
IMPORTANT INFORMATION
Please take time to read these instructions before use in order to familiarise
yourself with the operation of the lighting system. We strongly advise you
read the following recommendations in order to prevent injury or damage to
the lighting system.
MAINTENANCE
DISPOSAL
When the equipment has reached the end of its life please dispose
of the components in accordance with your local waste regulations.
Lamps and batteries should be recycled where possible and not
disposed of with regular waste.
WARRANTY
All Hope Technology lighting systems are covered for two years from original
date of purchase against manufacturer defects in material and workmanship.
Proof of purchase is required. Product must be returned to the original retailer
to process any warranty claim. This warranty does not cover any damage
caused through mis-use or failing to comply by the recommendations given
in this manual. This warranty does not affect your statutory rights.
If you find that the power connectors are becoming difficult to separate, we
advise using a small amount of silicone lubricant on the battery connector
to ease fitting. There are no serviceable parts inside either the light unit or
battery pack. Please do not attempt to disassemble the units, as this will
invalidate the warranty. If you find that there is a problem with the
functioning of the lighting system please first check that the battery pack
is fully charged (see Charging the Battery Pack section). If the light still
fails to function please contact Hope Technology.
››
This lighting system will withstand harsh wet weather conditions.
However, it is not designed to be submersed in water. Please ensure that
the light unit and battery pack are removed from the bike before washing -
particularly if using a high pressure jet wash.
››
Class 2 LED. Do not look directly at the
beam. Permanent eye damage could result.
Consider other road users when mounting
the light to avoid dazzling them. Always
position the light so that it is pointing
slightly downwards so it is not possible
to dazzle road users behind (see fig. 1).
››
Keep this light away from children.
››
Only connect the rear light to a
compatible Hope Vision 7.4 V battery pack,
either directly or through the supplied splitter
cable. Any attempt to use or charge another
battery pack may result in an explosion
and/or serious injury.
››
Do not short-circuit the battery terminals. This causes the battery
to overheat and could result in fire or explosion.
››
The battery charger is designed for indoor use only and should
not come into contact with water.
››
The battery charger contains dangerous voltages and the cover should not
be removed. Any attempt to open the charger will invalidate the warranty.
5.
Hook & loop cable straps (x3)
6.
Rechargeable battery pack
7.
Battery strap
8.
Battery charger
1.
D rear LED lamp unit
2.
QR elastic ring mount
3.
Elastic rings (x3)
4.
Splitter cable
KIT 1
KIT 2
KIT 3
