Hoobico FLW4090, Инструкция по сборке и эксплуатации

Страница: 7 / 16

7
ENGLISH
Now you can glue the rudder to the fuselage. Take care, that
the pivot point of the rudder is the same like from tail wheel
suspension. If it is ok, you can drill 2 holes with a 1.5 mm drill
through the aluminium plate and fix it with 2 pcs of 10 mm
woodscrews.
Push the collar upwards to the aluminium plate and fix it with
the set screw. Us locking agent for the set screw.
Screw the eyebolts halfway into the swivel ball links and
mount it to the rudder lever, using the M2x10 screws, shims
and nuts. Use blue locking agent for the nuts. Contrive the
steel rope into the eye bolts and the sleeve. The rope should
withstand over the sleeve,1 cm in flight direction. Then crimp
the sleeve with suitable pliers. Bend the withstanding rope
backwards 180 degrees and supply it with a shrink tubing.
18 mm from the lower side of the rudder drill a 2 mm hole for
the nosing of the tailwheel suspension.
From the hole downwards make a little ditch for the 2mm
steel wire of the tailwheel suspension.
Before gluenig the suspension to the rudder, take care that all
parts like collar and aluminium plate are in position. Sand the
steel wire a little and glue it, like in the picture, into the rudder.
Use 5 min epoxy glue.