Hoobico FLW4090, Инструкция по сборке и эксплуатации

Страница: 10 / 16

10
ENGLISH
Assemble the linkages like you can see in the picture. For
maximum movement use Flitework carbon fiber servo lever
extensions.
INSTALLING THE RC COMPONENTS
The installation, shown in the following pictures, should be
only a possibility and is not obligatory. It is important, that
the position of the antennas is not behind a silver coated film
of the fuselage. Silver coated film contains aluminium, which
decreases the strength of the radio signal.
The aileron servos can be plugged to 150 mm servo extension
cables, which are coming from the receiver. So you can remove
the wings very easy.
Here you can see the position of the battery, which is fixed
with a Flitework battery belt. The battery is placed on an anti
slip map.
Always take care that you have plugged in the
aileron servos after completing your plane for
flying.
ASSEMBLING THE MAIN WINGS
Glue the hinges to the flaps and afterward to the wings with
the same method like rudder and elevator. Take care for
smooth and wide movement of the flaps. A sticker arround
the slots for the flap lever prevents for making glue spots.
Sand the levers a little and glue them into the flap slots, using
5 min. Epoxy.
Drill 1.5 mm holes through the servo mounting flanges and
fix the servos with adequate screws from the accessory set of
the servos.