Hongli A200, Руководство по эксплуатации

Страница: 5 / 9

4
2. Inspect the power cord and plug for damage. If
the plug has been modified, is missing the
grounding prong or if the cord is damaged, do not
use the Drain Cleaning Machine until the cord has
been replaced.
3. Inspect the Drain Cleaning Machine for any
broken, missing, misaligned or binding parts as well
as any other conditions which may affect the safe
and normal operation of the machine. If any of these
conditions are present, do not use the Drain
Cleaning Machine until any problem has been
repaired.
4. Lubricate the Drain Cleaning Machine, if
necessary, according to the Maintenance
Instructions.
5. Use tools and accessories that are designed for
your drain cleaner and meet the needs of your
application.
The correct tools and accessories allow you to do
the job successfully and safely. Accessories suitable
for use with other equipment may be hazardous
when used with this drain cleaner.
6. Clean any oil, grease or dirt from all equipment
handles and controls. This reduces the risk of injury
due to a tool or control slipping from your grip.
7. Inspect the cutting edges of your tools. If
necessary, have them sharpened or replaced prior
to using the Drain Cleaning Machine. Dull or
damaged cutting tools can lead to binding and cable
breakage.
8. Inspect cables and couplings for wear and
damage. Cables should be replaced when they
become severely worn or corroded. A worn cable
can be identified when the outside coils become flat.
Worn or damaged cables can break causing serious
injury.
Machine Set-Up
WARNING
Do not place machine in water. Water entering
the motor can result in electrical shock.
To prevent serious injury, proper set-up of the
machine and work area is required. The following
procedures should be followed to set-up the
machine:
Set-Up For 1 1/4″ (32mm) Sectional Cable
1. Check work area for:
• Adequate lighting
• Grounded electrical outlet
• Clear path to the electrical outlet that does not
contain any sources of heat or oil, sharp edges or
moving parts that may damage electrical cord.
• Dry place for machine and operator. Do not use
the machine while standing in water.
• Flammable liquids, vapors or dust that may ignite.
2. Position the Drain Cleaning Machine within 2′ of
drain inlet. Greater distance can result in cable
twisting or kinking.
3. Make sure FOR/OFF/REV switch is in the OFF
position.
4. Insert first cable into front of machine (female end
first) and push through until approximately one foot
remains out the front of the machine (Figure 2).
Figure 2 – Inserting Cable Into Front Of Machine